Jetted Tub Installation

Tubs with 120 volts are plugged into gfci ground fault circuit interrupter receptacles.

Jetted tub installation.

Find local contractors to install or replace a whirlpool tub. Set the drain inside the tub in plumber s putty make a rope of it about 1 2 in. Then the top often made of stone or marble is cut and fitted over the tub to serve as a kind of lid for the casing. Place the putty on the base of the drain and then insert the drain through the drain hole.

Electrical installation requirements for jetted whirlpool tubs nothing says master bathroom like a whirlpool spa tub. Set the tub in place now connecting the drain as the tub is lowered. Having the space for a bathtub and the time to relax in it is the ultimate sign of luxury. The whirlpool tub motor must be wired to its own dedicated circuit in the service panel.

In diameter and stick it on the underside of the drain before you push the drain through the bottom of the tub. In many cases the instructions say to fill the tub with water at this point to ensure full contact with the bedding material. The final procedure in a jetted tub installation is to install a faucet and whereas most plumbers routinely use 1 2 inch copper or pex pipes for a tub water supply the national kitchen and bath association recommends 3 4 inch pipe for large tubs that demand higher water flow. It s important that the bedding material remains in full contact with the base of the tub and doesn t flow away.

Tubs requiring 240 volts must be directly connected to the power supply. Install the tub first followed by its decorative casing. Use a tub drain wrench to hold the drain in place and be certain the putty squeezes out on all sides of the edge of the drain. Homeadvisor will connect you with prescreened jet bathtub installation contractors in your area.

If your whirlpool tub has a heater that must have its own dedicated circuit as well.