Installing Above Range Microwave With Vent

In addition there should be approximately 20 inches 51 cm to 24 inches 61 cm between the bottom of the microwave and the top of the range.

Installing above range microwave with vent.

That involved a jack hammer like powertool and lots of dust. Make sure you pay close attention to your specific vent s. Remove the motor mounting screws on the back of the oven. Install your over the range microwave venting by inserting it into the hole you have just made from inside your kitchen to the outside.

If the duct installation has been correct the microwave s vent fitting should slide smoothly into the collar of the exterior vent cap. Connect the metal ductwork to the vent opening on the microwave. Wiring a microwave. Gently pull the rings and lift vent screen from the top of the microwave oven.

The minimum allowable clearance between the cabinets is 30 inches. Take out the motor and rotate it 90 degrees so that the fan motor now blows upward. The first step to install over a range microwave is to measure the cabinet opening. To install vent deflector.

We wanted one that vented outdoors but we have open space instead of a soffet or low ceiling above the cabinets so it had to vent through our cinderblock exterior walls. But often minor adjustments are needed to make the connection between microwave vent and the duct. Installing a microwave oven over a range typically involves installing a dedicated 120 volt 20 amp circuit and placing a receptacle outlet in the upper cabinet above the range. In kitchens it is common practice that if a microwave oven will be installed at a given.

A standard countertop microwave oven takes up a large footprint and in small kitchens with limited counter space this can be a big inconvenience. Remove the access plate on the top of the unit in order to reach the motor. Check to make sure your microwave can be installed at the proper height. While the minimum distance from the cooking surface to the bottom of the cabinet is also 30 inches.

To prepare the microwave oven for wall or roof venting the vent deflector l shaped metal bar must be installed and the appropriate damper vent opening must be uncovered. Attach the transition piece to connect the oven to ductwork. When we swapped out our over the range microwave for a range hood it was not nearly so simple. Before you go ahead.