Installing A New Bath Surround

Shower pans are often included in the shower surround kit.

Installing a new bath surround.

The basic installation can be finished in a day after sizing and fitting the panels. Finish cutting and binding the surround panels to give your bathroom a new look. Measure and mark the location for the top of the ledger usually about 1 inch below the first mark. Predrill 3 16 inch diameter screw holes through the surround s flange then fasten the surround to the studs with 1 inch long decking screws.

Push the panel back in place. If you are installing a new bath you will need to support it with a timber frame. The first step should of course is to turn off the water. How to install a bathtub.

Press it firmly onto the wall then pull it back about 6 inches for a few minutes or per the manufacturer s instructions to let the adhesive set up. Push the tub into the enclosure and mark the top of the flange on the wall studs with a pencil. Installing a bath isn t a particularly difficult project. Remove the wood blocks and set the surround down onto the tub.

The first step in installing a tub is to set in place a ledger board that supports the edges of the tub that contact the walls of the tub enclosure. Watch our step by step video showing how to install a standard acrylic bath with expert advice and top tips to help you complete the job with confidence vis. Then attach the drain to the new tub and connect the overflow drain. Apply a continuous bead of silicone caulk around the upper edge of the tub.

As long as you plan thoroughly and work in a methodical fashion you should be able to achieve a satisfactory end result. If you are installing a new surround instead of replacing an old one you can attach the panels directly to the walls without having to remove anything. Install an acrylic tub and tub surround remove an old plastic bathtub and surround and install a new bathtub and three piece surround with new plumbing and a tile border. Follow the manufacturer s directions for installation.

Here we work through the steps for installing a new bath in the order you are likely to encounter them. To install a bathtub start by installing a 2 by 4 inch ledger board to the length of the wall that the long edge of the tub will be against. Next set the tub in place and secure it to the studs using the vertical lip around the outside of it. Install the first corner panel position the panel on the wall.