Infant Car Seat Baseless Installation

Please support car seat org with your purchases of infant convertible combination and boosters seats from our premier sponsors above.

Infant car seat baseless installation.

Thread the lap section through the lap belt guides on the car seat. Press down firmly on the car seat base and tighten. How to properly install an infant seat without the base presented by vancouver island. There are plenty of ways you can install your infant car seat incorrectly.

You also get a much more secure baby seat which doesn t wobble in your car which brings valuable peace of mind for any parent. Shop travel systems strollers and baby gear from britax chicco clek combi evenflo first years graco maxi cosi nuna safety 1st diono more. Place your car seat rear facing on the vehicle seat. 2001 2020 carseat media llc.

The most common infant car seat install mistakes. The base should not move side to side or front to back more than 1 inch. Pull out the seat belt. Installing child car seats used to be worse than building an ikea cupboard from scratch but with the introduction of isofix child seats much of the mystery has been solved.

The latch system is designed to make installation of a car seat easier and safer by attaching the car seat directly to anchors permanently attached to the vehicle instead of using the seat belt to secure the seat. Always read your car seat manual and vehicle manual carefully this video is not a replacement for either. Make sure your car seat base is installed at the correct recline angle. Position car seats in the back seat.

Although only front facing infant and toddler car seats are required to have both the upper and lower attachments all child safety. If your car seat has a european belt path you will pull the shoulder belt behind the car seat and secure it in that belt path. Rear facing seats with an incorrect recline angle. Don t try guessing read the directions thoroughly and make sure you clearly understand how to securely install the car seat.

A baseless car seat installation is possible even without a european belt path. That gives the car seat two spots where the seat belt holds it in rather than just one. Put the shoulder belt portion through making sure it lies flat. Let s walk step by step through a baseless car seat installation.

While car seat installation may vary slightly from vehicle to vehicle there are some basics that always apply. Most infant car seats have built in angle indicators or adjustors to assist you. Babies must ride sitting semi reclined to keep the airway open.