Ice Machine Installation Requirements

Most ice machines must be installed with a certain amount typically between 5 to 14 inches of clearance on each side though some are engineered for flush installation with walls or other equipment.

Ice machine installation requirements.

Verify the water completely drains from the ice bin and there are no leaks. That includes any minerals that might be in the water. First you will need a powerful source of electricity 115v or 220v depending on the ice machine size. If the water has not drained within 60 sec onds there may be a kink in the drain tube or the drain installation is incorrect.

The smaller commercial ice units require a 1 4 inch water supply and it goes up from there most need at least a 3 8 line. To properly drain the ice maker or storage bin 1 4 of drop is required for every 1 foot of drain line length. Beyond that water supplies vary in the degree of mineral content. As this ice machine makes ice all the water that flows into the machine is changed into ice.

You may also require a dedicated breaker depending on the amperage size. Let s say you want to use an access point on one side of a room but your ice machine is installed at a distance where the proper drain slope is not achievable. Floor drain within six feet next you will need a floor drain within close proximity of your ice maker. 2 add one gallon 3 8 l of cold water to the ice bin.

Installation of the ice maker requires a cold water supply inlet or a whirlpool supply line part number 8212547rb and a whirlpool approved drain pump part number 1901a only to carry the water to an existing drain. The water to the machine must be potable or fit for human consumption. This is where a transfer drain is most useful. Doesn t present a tripping hazard.

The ajax ice installation teams love to find an angle stop type valve with a flare or compression style connection. Choose a well ventilated area with temperatures above 55 f 13 c and below 110 f 43 c. Installation of the ice maker requires a cold water supply inlet of 6 35 mm od soft copper tubing with a shutoff valve or a whirlpool supply line part number w10505928rp and a whirlpool approved drain pump part number 1901a only to carry the water to an existing drain. Installation installation verify ice production 1 press power to turn the ice maker on.

The ice maker should not be installed near ovens ranges grills or other heat emitting equipment.